Update the greenhouse screen with one click

Connect the device with a USB cable and press one button. After selecting the port, the update starts automatically.

Chrome or Edge

The flasher uses Web Serial, so open this page on a computer in Chrome or Edge.

One device type

The package is prepared for our ESP32-S3 screen. The user does not need to choose addresses, PSRAM or flash settings.

Ready firmware

All board settings are already included in the update. Just connect the device and press the button.

Firmware package

Loading firmware description...

Idle

Version -

Device -

Erase flash before writing Optional. Usually leave this off. Enable only if the device works unstably after an update or old data must be fully cleared.

Do not disconnect USB during writing. If the device does not enter flash mode automatically, hold BOOT while connecting.

Progress 0%

Log

Ready.

Need wiring documentation?

The GitHub project describes the screen, sensors, relay board, GPIO wiring, Gerber files and firmware binaries.

Open GitHub documentation